Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
- Keithley Applications
- Posts: 1543
- Joined: October 15th, 2010, 10:35 am
- Country: United States
From the specifications/data sheet, the voltage set accuracy has a 5volt adder when the filters are in use.
Voltage Set Accuracy = 0.01% of setting + 2.5v + 5v if filter in use
Also note that the voltage regulation specs apply for values of 25 volts and higher (full load) or 50 volts and higher if no load.
I had not enabled the filters, but I was not aware of the regulation specs for no load vs load. I'm planning on getting a tee divider so that I can put a load on and still drive what I need. But I still want this supply to be able to give me voltages under 25V, but it looks like I'll need to create a voltage divider network in order to get below 25V.
Who is online
Users browsing this forum: No registered users and 2 guests