Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I am currently using Keithley 2636B with LabVIEW to measure IV characteristics of a FET. SMU A sweeps source-drain voltage and measure current while SMU B sweeps gate and measure current. I used the trigger model to communicate two SMUs.I need to measure the current with time and plot I vs time. However, the timestamps of the two channels show two different times. Whatever the measurement delay of SMU B, the timestamps values of SMU B does not change. I attached both timestamps data of measurement delay at 2s. How can I get measurements of both SMUs at the same time?
- Picture1.png (114.68 KiB) Viewed 493 times
Who is online
Users browsing this forum: No registered users and 1 guest