Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Labview blocks documentation

Post Reply
ribfernando
Posts: 1
Joined: March 11th, 2014, 9:40 am
Country: Portugal

Labview blocks documentation

Post by ribfernando » March 11th, 2014, 10:18 am

Hi,

I'm using labview to control a small experience using keithley 2425C equipement.
I installed the last version of the labview drivers.
I noticed that blocks on the ke24xx labview palette doesn't have "help" documentation.
I know, lots of LV blocks have the same functions of the codes described in the equipement manual, but... there is some documentation for the LV blocks?
I really don´t know what are the inputs/outputs of some blocks. I'm struggling to find what block allow the 4 wire sensing.


Best Regards,
Fernando Ribeiro

Dale C
Keithley Applications
Keithley Applications
Posts: 2845
Joined: June 10th, 2010, 6:22 am
Country: United States
Contact:

Re: Labview blocks documentation

Post by Dale C » March 11th, 2014, 10:44 am

If you are using the native Labview driver the remtoe and local sense (2 or4 wire) control is located in the
Configure basic Source-measureVI.

Post Reply

Return to “LabView Drivers”

Who is online

Users browsing this forum: No registered users and 2 guests