Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I installed the KUSB-488B drivers for my Win 7_64 bit laptop.
Then I connected my laptop with teh KUSB-488B and Keithley 6517B.
But the "Found new hardware dialog box" did not display on my computer screen, even I tried several different USB ports.
Then I restarted my laptop, the "found new hardware dialog box" still did not appear.
So I can not continue to install the hardware.
But I can see the Keithley 6517B if I open the KI-488 configuration utility.
What should I do to install the hardware? Is it ok now?
On the other hand, I found there are some 6517A/B LabView Driver on the website of Keithley.\
Should I also install the 6517A/B LabView Driver?
Or KUSB-488B driver is the whole thing I need to install?
- Keithley Applications
- Posts: 1271
- Joined: October 15th, 2010, 10:35 am
- Country: United States
The KUSB-488B is a GPIB interface for a computer and can enable communication with any instrument that has a GPIB interface. You should not expect anything specific to the 6517B from the driver software related to the KUSB-488B.
If you are intending to use LabVIEW, then the LV driver for the 6517B may prove helpful to construct a program. Alternately, you can use the VISA read and write or GPIB read and write VIs of LabVIEW to send the native SCPI commands understood by the 6517B.
Who is online
Users browsing this forum: No registered users and 8 guests