Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

how to use TSP express software

Use this forum for questions about Keithley Test Script Builder software.
Post Reply
jiamawork
Posts: 1
Joined: July 14th, 2011, 5:57 pm
Country: United States

how to use TSP express software

Post by jiamawork » July 14th, 2011, 6:00 pm

how to use TSP express software and 2601A source meter to perform battery charge and discharge tests?

Gabriele V
Keithley Applications
Keithley Applications
Posts: 38
Joined: November 2nd, 2010, 6:51 am
Country: Italy

Re: how to use TSP express software

Post by Gabriele V » July 15th, 2011, 7:08 am

Hello jiamawork,

TSP express is especially designed for a device characterization and curve tracing.

For your application I would suggest to use the scripting that give you better performances and more control on the charge and discharge process.

May be during the charge you want to check the "Negative Delta Voltage" point for your battery and this is possible using script because the unit can take decision during the execution. If you need you can also define a loop for trickle charge and so on.

A the same time, if you want to discharge the battery being sure that the voltage does not drop below certain level this is the right approach.

I hope this can help
Regards
Gabriele

Gabriele Vittori
Application Engineer
Keithley Instruments (Italy)

Post Reply

Return to “Test Script Builder”

Who is online

Users browsing this forum: No registered users and 4 guests