Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
1) read its identification string
2) command it to Source I Measure V as DC
3) set it to source (and hold) one specific current (say 23.45 microAmps)
I do not need to sweep through a range or measure anything.
I understand the version of GPIB is old and will not recognize queries like *IDN?, but I cannot find specifically from the manual how to do the above.
Any help is appreciated. Thank you.
- Keithley Applications
- Posts: 2847
- Joined: June 10th, 2010, 6:22 am
- Country: United States
Who is online
Users browsing this forum: No registered users and 0 guests