Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

Fatal error

Model 2651A
Post Reply
Maura84
Posts: 1
Joined: September 20th, 2013, 4:24 am
Country: Italy

Fatal error

Post by Maura84 » September 20th, 2013, 4:38 am

Dear Keithley Engineers,

I am experiencing an error in 2651A today when doing I-V measurements, sourcing the instrument in costant current mode set at 1A.
After few seconds, the current started to increase and suddently there was no more response at all when I pressed any button. So I switched it off and on again and it shows now two errors that the manual classifies as "FATAL". They are: ERROR 5051 and ERROR 5001.
Could you suggest any solution?

Thanks a lot for your help.

Maura

Dale C
Keithley Applications
Keithley Applications
Posts: 2847
Joined: June 10th, 2010, 6:22 am
Country: United States
Contact:

Re: Fatal error

Post by Dale C » September 26th, 2013, 10:03 am

I discussed with the service department.
Sounds like this unit is in need of service.
Please contact your locak Keithley/Tektronix repair facility.

Post Reply

Return to “2651A High Current SourceMeter”

Who is online

Users browsing this forum: No registered users and 1 guest