Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I have a 7002 switch with 7011-C and 7035 cards that was built many years ago. Recently, I duplicated this system with all new hardware. However, the voltage levels in my system are not correct. When I swap the new 7011-C cards out with the old ones, the new system works correctly. In the same way, placing the new 7011-C cards in the old system duplicates the problem. Has the design of the 7011-C card changed? Or is there some required configuration of the card that I'm not aware of?
- Keithley Applications
- Posts: 2849
- Joined: June 10th, 2010, 6:22 am
- Country: United States
Can you define what you mean by th voltage levels are not correct?
Is this the signal being routed through the 7011-C card?
Or is it the relay drive voltage on the card?
Who is online
Users browsing this forum: No registered users and 1 guest