Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I am trying to use BICC on top of M3UA/M2PA but the BICC encoder/decoder is causing corrupt messages. The first 4 bits of the BICC message according to the G35 is 'spare SLS' rather than part of the 4 byte CIC field. This is causing the remaining bytes to be decoded incorrectly.
Has anyone used BICC before as I cannot believe this basic error has not been seen before!
I have raised a fault ticket to Tek but any help/advice would be appreciated.
Who is online
Users browsing this forum: No registered users and 4 guests