Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
- Posts: 93
- Joined: September 23rd, 2014, 6:14 am
- Country: United States
I have been trying to program the AFG in the MDO3014 to output a 5V DC level. Using the following instructions.
Code: Select all
The output of the AFG is routed to channel 1 using a 50ohm coax cable. Channel 1 is set for high impedance.
However, the maximum level displayed is 2.5V.
What is the correct instruction set to display a 5V DC level?
- Tektronix Applications
- Posts: 558
- Joined: July 31st, 2008, 8:26 am
There is no amplitude for a DC level. For a DC waveform there the only voltage control is offset. The offset range for the AFG function is +/- 2.5 volts into high impedance, so the maximum DC level is 2.5 volts
Who is online
Users browsing this forum: No registered users and 1 guest