Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I have slowly changing signals typically in the 0.1 - 1 Hz which I want to observe on a scope. I'm measuring things like slowly-changing temperatures.
When making any change on the scope front panel while observing slow signals here are the 3 types of scope responses I've observed:
1. The scope screen freezes for 6-12 seconds before it "comes alive" again and shows the moving trace. I have observed this behavior in a Rigol 1054Z and Keysight DSO-1002A.
2. Scope clears the screen and immediately starts a new trace from the edge of the screen. But no 6-12 second dead time. I see this behavior in an Instek GDS-2104E and an Instek GDS-1054B.
3. Scope immediately performs the front panel setting you made and simply carries on with the display at the new setting: No 6-12 second dead time, no blanking and restart of the trace. Just keeps going. This is the best behavior of course, and I see this on a Tek DPO-3034 and Tek TDS-2012.
My Question is: How do I refer to this behavior, that is, what do I call it? If I'm talking with an apps engineer at an instrument company and I want to know if their scope handles this scenario (slow signal display) according to options 1, 2, or 3 above, what do I ask??
I've searched oscilloscope forums and I don't see this feature of scope operation addressed. Is this addressed in the spec sheet for a scope? What do I look for? I know most folks don't care much about how well a scope goes slow; we want them to go fast, right? But I would appreciate if anyone could point me to where I can find some answers...
Thanks all, and again sorry for the long-windedness.
Who is online
Users browsing this forum: No registered users and 2 guests