Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
Bought a brand new MDO3014 with firmware v1.26 but, I cannot use it because Windows 10 does not recognize the instrument USB. Help!
The NI VISA 2017 drivers are installed. I have an NI GPIB to USB interface connected to a USB 2.0 hub. I am able to see all the GPIB addresses for other instruments. The MDO3014 USB port is connected directly to the PC. However, the PC cannot find the instrument.
When I check Device Manager on the PC, the MDO3014 properties show that “The drivers for this device are not installed.” “There are not compatible drivers for this device.”
I have tried to update the driver by selecting “Browse my computer for driver software”, then “Let mi - from a list of available drivers on my computer”. There are too many.
Which USB driver do I select?
Both recommendations were already implemented. Yes, the USB device Port is set to "Connect to Computer". I dis-connected the USB cable on the oscilloscope side and reconnected it again. No change.
If still no success I would recommend submitting a support request so we can further assist in sorting out the issues. You can submit a support request at: https://www.tek.com/support
Who is online
Users browsing this forum: No registered users and 1 guest