Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I am writing a Labview program to operate the 2400 to do a I-V hysteresis sweep. (i.e) to run from 0V to 1V to -1V and back to 0V.
I have the instrument drivers for building the VI in Labview but am unable to find the option to do the hysteresis measurement.
Is it possible? If not how would I go about doing this?
Any help will be greatly appreciated.
Please refernce the 2400 users manual for more information.
Mark - Applications
Thank You for the reply.
The Read.vi contains the sweep mode. And the configure output sweep.vi contains whether the sweep should be ascending or descending. Is that what you are talking about?
Also How do I use the Abort.vi to abort a measurement int eh middle?
Once the read.vi is triggered, it runs the measurements based on the configurations specified, How to I continuously poll a boolean to see if a stop button is pressed, then run the abort.vi in the middle of a measurement?
Thank You for the help.
Who is online
Users browsing this forum: No registered users and 0 guests