Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

DMM6500 LabView Read (Multiple Item) error: trigger model

DMM6500 6½-Digit Touchscreen Multimeter
Post Reply
[email protected]
Posts: 5
Joined: January 7th, 2019, 1:02 pm
Country: Belgium

DMM6500 LabView Read (Multiple Item) error: trigger model

Post by [email protected] » January 22nd, 2019, 11:35 am

I'm testing the LabVIEW example in Keithley's DMM6500 driver lib: Keithley DMM6500 DAQ6500 Series General Scanning.vi
(I have tried simpler examples of the lib before and they work).

I've set the pseudocard to 0 because no card installed.
The example runs fine until step Read (Multiple Item)
When I enter that point, the error signal is still green, all ok.
before.jpg
Before the Read (Multiple Item)
before.jpg (293.98 KiB) Viewed 1363 times
When I execute Read (Multiple Item) I get this error:



Error:
Instrument reports:
2710,"Unable to initiate, no block number 1 in trigger model;1;2019/01/22 20:32:57.568"
0,"No error;0;0 0"

Complete call chain:
Keithley DMM6500 DAQ6500 Series.lvlib:Error Query.vi
Keithley DMM6500 DAQ6500 Series.lvlib:Query Operation Complete.vi
Keithley DMM6500 DAQ6500 Series.lvlib:Read (Multiple Points).vi
Keithley DMM6500 DAQ6500 Series General Scanning.vi

after.jpg
After the Read (Multiple Item)
after.jpg (342.45 KiB) Viewed 1363 times
When I change the Read to Single Item and change the output to a normal indicator it works. The error appears for Multiple Item only.

I've attached a screen capture before and after the Read block.
What error do I make?

Post Reply

Return to “DMM6500 Bench/System DMM”

Who is online

Users browsing this forum: No registered users and 0 guests