Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
I have a problem using IVI drivers for 2380-500-30 in LabWindows/CVI IDE. I've successfully loaded the instrument (.fp file) into project, but each time I try to set some parameter, device goes to error mode (ERROR mark is activated on display), which cannot be cleared until the device power is cycled. I managed to read measurements without any problem, but each time the command is sent it goes to error. Does anyone have any sample code I could use? The examples which came with the drivers are covering only .dll implementation. Thanks!
Who is online
Users browsing this forum: No registered users and 0 guests