Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.
V comp is set to 8v.
I init the sweep, the k2400 starts @-103mA and ends @130mA as seen on the dsiplay.
I transfer the buffer and plot and it shows the sweep starts and ends at ~ +-60mA keeping the number of steps correct. There are several points at compliance on either end.
Does the K2400 automatically scale the dCi when it hits compliance on a memory sweep? I don't see any reference of this in the tech manual.
I can increase the current range by increasing Vcomp. Of course if I never hit vcompliance the entire current range sepcified is in the buffer.
- Keithley Applications
- Posts: 2849
- Joined: June 10th, 2010, 6:22 am
- Country: United States
This maybe the reason you are seeing the current range shift.
Sometimes it is advantageous to go into compliance, but not in this case.
I would recommend to either increase the compliance level(if your device can take it) or decrease the current level so as not to go into compliance.
Who is online
Users browsing this forum: No registered users and 1 guest