Tektronix Technical Forums are maintained by community involvement. Feel free to post questions or respond to questions by other members. Should you require a time-sensitive answer, please contact your local Tektronix support center here.

External trigger save waveform

Post Reply
Posts: 1
Joined: October 29th, 2018, 5:25 am
Country: Romania

External trigger save waveform

Post by dusty999 » October 29th, 2018, 5:45 am

I use a DPO4104B oscilloscope to store on an attached USB memory stick the waveform every n seconds (n>3s), for N times (N<1000). Could it be triggered the SAVE command (done by the SAVE push button) by some USB commands WITHOUT user intervention in some computer interface?
I do not use LabView, nor intend to do so.
I think about communication with a micro-controller capable of sending a set of characters over the USB port.


Post Reply

Return to “Programming Support”

Who is online

Users browsing this forum: No registered users and 1 guest